| Quick Help
This
page allows you to set up weekly schedules. This defines an event that
will happen one or more days of every week until the schedule is
deleted. The "on" time is that period of time between the given on
time and off time. During the "on" time, the "on" value will be applied
to the given register. The rest of the time, the register will be set
to the off value. The on and off values are applied once at the start
of the period, any time the system is rebooted, and any time the clock
is changed.
Select
which days of the week this schedule should apply to by checking the
days of the week. If one or more holidays should be excluded from this
weekly schedule, click on "Holidays" and select those holidays that
should be excluded. During a holiday, the "on" value will never be
applied unless the schedule entry above spans both holiday and
non-holiday time. To
reference the astronomical clock instead of fixed time of day, enter
DAWN or DUSK in place of the HH:MM:SS on and off times. An offset
in minutes may be included. To specify one half hour after sunrise,
enter "dawn+30". To specify one half hour before sunset, enter
"dusk-30", etc. Upper/lower case does not matter; however, do not
include any spaces in the dawn/dusk string. Latitude, longitude, and
time zone must be set in the Time & Datepage in order for the astronomical clock to work. You
do not need to duplicate a schedule entry to activate multiple outputs
according to the given schedule. Make a single schedule entry that
applies to a single register, then cascade that register to any number
of other registers with one or more cascade rules set up on the Cascade page. | | |
